NEC Univerge sv8500 Manual page 834

Setting Ethernet Speed:
--- Ethernet Speed set ---
Current LAN Speed: AUTO
Change LAN Speed? [Y(change)/N(current)/Q(quit)]: Y
Input new Speed [1(AUTO)/2(100M)/3(10M)]: 2
Input new DUPLEX [F(full)/H(half)]: F
Line 2: The current setting is displayed.
Line 3: Asked whether to change the displayed setting.
Y=change
N=not change
Q=quit this setting
Line 4: Select the communication speed of LAN interface
1=Auto negotiation (default)
2=100Mbps fixed mode
3=10Mbps fixed mode
Line 5: Select the Duplex mode of LAN interface
F=Full duplex mode
H=Half duplex mode
Save the assigned configuration data at the last of SETUP SP command to complete network setting.
**Don't power off in progress**
Do you save the configuration data? (Y/N):Y
Configuration data has been saved.
Restarting is required for making a setup reflect!!
SP mode setting succeeded.
The register mode will be changed to SP mode after re-starting
Line 2: Asked whether to save the assigned data.
Y=Save
N=Not save
Line 3: Result is displayed.
3. Set up network environment for MG-COT Card Proprietary Protocol mode.(SP-3875 6MGCOT PROG-A
Ver.3.0.0.0 or earlier)
To setup IP related data in dialog format. This command is used to simply assign the data related to IP ad-
dress.
• When DHCP option is used (to get DRS address):
MG-COT Card [SCA-6COTA/SCA-6COTC]
VOL.2-581