NEC Univerge sv8500 Manual page 1295

STEP 6: ADPC (Assignment of Determinate Point Code Data)
Assign the Point Code (1
Point Code must be different from the Point Code for CCIS. (ISDN does not actually use the Point Code
but it is necessary to develop the office data.)
NDM command (ADPCN) cannot be used here.
Note:
STEP 7: ACSC (Assignment of CSC Data)
Assign Virtual Speech Channel into the even-numbered (130
Channel into the odd-numbered CSC group.
NDM command (ACSCN) cannot be used here.
Note:
• PRI (1.5M): 23B+D setting.
CSCG
130/131
STEP 8: ACIC1 (Assignment of CIC Code Data 1)
Assign the accommodated location of Virtual Signaling Channel to the Point Code.
NDM command (ACIC1N) cannot be used here.
Note:
PC: Point Code specified by ADPC
CSCG: CSC group of Virtual Signaling Channel specified by ACSC
STEP 9: ACIC2 (Assignment of CIC Code Data 2)
Assign the CIC Number and accommodated location of Virtual Speech Channel to the Point Code.
PC: Point Code specified by ADPC
CIC: The same CIC number must be given to one speech line between two nodes.
LENS: Accommodated location of Virtual Speech Channel
STEP 10:ATRK (Assignment of Trunk Data)
∼ 16383) on Virtual Speech Channel and Virtual Signaling Channel. Note that the
CICG
(00-07)
0
1
2
3
4
5
6
7
VOL.2-1042
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
∼ 254) CSC group, and Virtual Signaling
CCH
MG U
(0-3)
02 0
02 0
02 0
02 0
02 0
02 0
02 0
02 0
* Required only for Q-SIG trunk.
G
(00-23)
04
04
04
04
04
04
04
04