NEC Univerge sv8500 Manual page 960

14. To show I/C call abandon timer
MG-COT > SHOW IC_ABANDON_TIME
I/C Call Abandon Timer is 0 (6sec).
15. To show communication speed for LAN interface
MG-COT> SHOW INTERFACE
Setting: 100Mbps Full Duplex
Status: Speed is 100Mbps, Half Duplex, Link Up
16. To show IP Address, Net Mask, and Default Gateway
MG-COT > SHOW IPADDRESS
IP Address: 10.4.128.5
Netmask: 255.255.255.0
Default Gateway: 10.4.128.254
17. To show One Time Password for security
MG-COT(SIP) > SHOW ONE_TIME_PASS
One Time Password: 12345
The designated One Time Password cannot refer when Proprietary Protocol mode. Assign the SP mode be-
Note:
fore executing this One Time Password shown.
18. To show Host Name of MG-COT Card
MG-COT(SIP) > SHOW OWN_NAME
Own Name: name1
The designated Host Name cannot refer when Proprietary Protocol mode. Assign the SP mode before exe-
Note:
cuting this Host Name shown.
19. To show Release Signal
MG-COT > SHOW RELEASE_SIGNAL
Release Signal is ON.
The current setting is shown.
Current setting of connection state is
shown.
Actual operating state is shown.
Line 1: Enter the interface name.
Line 2: IP Address is shown.
Line 3: Netmask is shown.
Line 4: Default Gateway is shown.
The current setting is shown.
The current setting is shown.
The current setting is shown.
VOL.2-707
MG-COT Card [SCA-6COTB]