NEC Univerge sv8500 Manual page 626

12. Setting frequency of Ringer:
MC-MG> SET RINGFREQ 0
Frequency of Ringer setting succeeded. (frequency is 20Hz.)
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
13. Setting default sender PAD value:
MC-MG> SET SENDPAD 0
Default Sender PAD setting succeeded.
The SENDPAD command assigns the value to decrease voice level in the sender (analog terminal to IP)
Note:
direction.
The total PAD value (Sender PAD + Fax Sender PAD) is limited to 20dB.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
14. Setting DSP smooth PAD mode:
MC-MG> SET SMOOTH_PAD 1
Smooth PAD Mode setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
MCMG [SCA-4LC2COTA/MG-4LC2COTA]
Line 1: Enter 0 or 1 to specify the Frequency of Ringer
0=20 Hz (default)
1=25 Hz
Line 2: Result is shown
Line 1: Enter the PAD value in the range of -10dB ~
20dB after the command name (default=0)
Line 2: Result is shown
Line 1: Enter a value of smooth PAD(1-5, OFF)
OFF=Set smooth PAD mode to OFF
1=2.0dBm (default)
2=-5.2dBm
3=-2.1dBm
4=0dBm
5=-4.2dBm
Line 2: Result is shown
VOL.2-373