NEC Univerge sv8500 Manual page 940

2. Set up network environment for MG-COT Card SIP mode
This command is used to setup the basic data for SIP mode. Setting display differs whether DHCP server
and DNS server is used or not. Assign the required network data following the setting command shown in
dialog form. Be sure to save the entered data at the last of SETUP command.
The designated operating status cannot refer when SP-3948 6MG COT PROG-A Ver.1.0.0.0 or later.
Note:
When any abnormal data is entered, the dialog asks to enter proper data until three times. In the third time
Note:
you enter abnormal data, the SETUP command quits discarding all the entered data.
When you quit the SETUP command entry halfway through the setting, all the entered data is to be discard-
Note:
ed.
Startup SETUP SIP:
MG-COT >
MG-COT > setup sp
Setting DHCP server enable/disable:
--- DHCP Interface set ---
Current DHCP Interface: ENABLE
Change DHCP Interface? [Y(change)/N(current)/Q(quit)]: Y
Input new DHCP Interface [E(enable)/D(disable)]: D
Line 2: The current setting is displayed.
Line 3: Asked whether to change the displayed setting.
Y=change
N=not change
Q=quit this setting
Line 4: Specify whether to use DHCP server.
E=Use DHCP server (default)
D=Not use DHCP server
Setting DNS server enable/disable:
--- DNS Interface set ---
Current DNS Interface: DISABLE
Change DNS Interface? [Y(change)/N(current)/Q(quit)]: Y
Input new DNS Interface [E(enable)/D(disable)]: E
Line 2: The current setting is displayed.
Line 3: Asked whether to change the displayed setting.
Y=change
N=not change
Q=quit this setting
Line 4: Specify whether to use DNS server.
E=Use DNS server (default)
D=Not use DNS server
Enter "SETUP SP" following the prompt.
VOL.2-687
MG-COT Card [SCA-6COTB]