NEC Univerge sv8500 Manual page 593

Assign the system data, according to the station numbering plan. Refer to the following for the prerequisite min-
imum data.
ASYD: Assignment of System Data
SYS1, INDEX 4, b2-b3
Assign the Releasing Method for Station-to-Station Calling Service
00 = Calling Party release
01 = Called Party release
10 = First Party release
11 = Both Party release
Normally, "10" = First Party release is assigned.
SYS1, INDEX 16
Assign the number level on station number composition
b0: 0/1 = 1-digit station number is not used/used
b1: 0/1 = 2-digit station number is not used/used
b2: 0/1 = 3-digit station number is not used/used
b3: 0/1 = 4-digit station number is not used/used
b4: 0/1 = 5-digit station number is not used/used
SYS3, INDEX 0
Assign the ringing pattern when a call from the C.O. line terminates to a station. Normally, "21" is assigned
in hexadecimal (1 second ringing, 2 second pause).
For details, refer to the Command Manual.
SYS3, INDEX 1
Assign the ringing pattern when a station is called from another station (Ringing Pattern 1).
Normally, "42" is assigned in hexadecimal (2 second ringing, 4 second pause).
For details, refer to the Command Manual.
SYS3, INDEX 2
Assign Station Release Timer (TS - release timing when connected to an ORT) and Hooking Timer (TL -
SHF maximum timing). Normally, "91" is set in hexadecimal (TS = 120 milliseconds, TL = 1,080 milli-
seconds).
For details, refer to the Command Manual.
ASYDL: Assignment of System Data (LDM)
SYS1, INDEX 811
Assign the Tone Code by countries. For more information, refer to the Command Manual.
SYS1, INDEX 813
Assign the PAD value of MC
MCMG [SCA-4LC2COTA/MG-4LC2COTA]
VOL.2-340