NEC Univerge sv8500 Manual page 1109

Sub-command
6 FAX_DETECTION_TIME
7 HC_RCV_TIMER
8 INTERFACE
9 LAN_ERROR_CHECK
10 ONE_TIME_PASS
11 OWN_IPADDRESS
12 RTP_START_PORT_NO
13 SIGNALING_PORT_NO
14 SIGNALING_QOS
15 SIPSV_IPADDRESS
16 SMOOTH_PAD
17 VLAN
18 WARNING_TONE_CONTROL
SAVE: Command to save the modified configuration
Sub-command
1 CONFIG
EXIT: Command to exit the configuration setting mode
Sub-command
1 -
REBOOT: Command to reboot the MG(BRI)
Sub-command
1 -
Displays the current setting of effective timer for FAX switching.
Displays the current setting of Time-out timer for SIP server health
check packet waiting process.
Displays the current setting for speed and activation mode of Ether-
net controller.
Displays the interval to detect LAN cable fall-off.
Displays the current setting of one time password.
Displays the current setting of IP Address, Subnet Mask, and Host
Name of MG(BRI) itself.
Displays the current setting of RTP Start Port Number.
Displays the current setting of Signaling Port number
Displays the current setting of QoS data for signaling session.
Displays the current setting of SIP server's IP address, port number,
and host name.
Displays the current Smooth PAD mode.
Displays the current VLAN setting.
Displays the current setting whether to send warning tone in the
case of LAN failure.
This command is used to save the modified configuration data to the
FlashROM.
This command is used to exit the configuration command of
MG(BRI).
This command is used to reboot the MG(BRI).
VOL.2-856
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Function
Function
Function
Function