NEC Univerge sv8500 Manual page 633

11. Setting Loop Prohibition timer
MC-MG > SET NO_LOOP_TIME 0
Loop Prohibition Timer setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
12. Setting Release Signal
MC-MG > SET RELEASE_SIGNAL OFF
. R elease Signal setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
13. Setting RTP Stop Detect Timer
MC-MG > SET RTP_STOP_DETECT 3
.
RTP Stop Detect Timer setting succeeded.
Assign this value as one of the conditions for MG Based Call Retention to determine that the call is re-
Note:
leased. The call will be determined released if RTP is not received exceeding the assigned timer value dur-
ing call retention.
MCMG [SCA-4LC2COTA/MG-4LC2COTA]
Line 1: Enter the Loop Propitiation timer (0-15)
0=608 ms (default)
1=128 ms
2=176 ms
3=224 ms
4=272 ms
5=320 ms
6=368 ms
7=416 ms
8=464 ms
9=512 ms
10=560 ms
11=656 ms
12=704 ms
13=752 ms
14=800 ms
15=848 ms
Line 2: Result is shown
Line 1: Select Release Signal Setting
OFF=Invalid (default)
ON=Valid
Line 2: Result is shown
Line 1: Enter
Effective range: 3-32 seconds (default: 3
seconds)
Line 2: Result is shown
VOL.2-380
RTP Stop Detect Timer