NEC Univerge sv8500 Manual page 404

<Data Assignment on Telnet PC>
Start a command prompt and enter "telnet <8LC Card's IP Address>" to connect
STEP 7
8LC Card via Telnet.
Log in to the target 8LC Card by entering userID and password, which are set in the AUTD
STEP 8
command.
After a prompt (->) is displayed, enter "usrConsole".
STEP 9
After a prompt (MC(SIP)>) is displayed, enter "get configdata <TFTP's IP Ad-
STEP 10
dress>" to download configuration data into 8LC Card.
Confirm that "successfully completed" is displayed in the command prompt, indicating the
STEP 11
upload to TFTP server is completed normally.
To reflect the configuration data that is downloaded from TFTP server, save it by entering
STEP 12
"save configdata" and reboot 8LC Card by entering "reboot".
Exit the HyperTerminal by selecting [File]
STEP 13
<Confirmation of 8LC Card>
Confirm that 8LC Card is normally registered in system after reboot. Use the DISD/FPTS
STEP 14
commands. For more information, refer to the Command Manual.
Check that calls via 8LC Card can be made.
STEP 15
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
VOL.2-151
→ [Exit].