NEC Univerge sv8500 Manual page 1238

Δ
25. SET TCS_PADP1
This command is used to specify PAD data for T1/E1. Before using this command, set Flexible (1) in PAD
selection of SET TCS PAD0. Fore more information about the procedures, refer to next page. To make this
assignment effective, it is required to execute the "SAVE" command and to restart before exiting the main-
tenance command. The following is an example of PAD1.
COMMAND 1
MG-PRI > SET TCS_PAD1
Flexible PAD #1-Recv( 0-36:0 ): 0
Flexible PAD #1-Send( 0-36:0 ): 0
set value is 0x0000
setting complete.
In order to make a setup reflect, saving a
configuration file is required by SAVE
command.
COMMAND 2
MG-PRI > SET TCS_PAD1 0000
set value is 0x0000
setting complete.
In order to make a setup reflect, saving a
configuration file is required by SAVE
command.
Δ
[P2]
VOL.2-985
P1-Specifying a PAD number
1-4=PAD Number
The available PAD number varies depending on the ARTD
settings (PBX side).
ARTD PAD AVAILABLE PAD No.
0/4 TCS_PAD4
1 TCS_PAD1
2 TCS_PAD2
3 TCS_PAD3
5/6/7 Not Available
P2-Specifying a set value
0000-FFFF= Set value (default value: 0000)
When P2 is omitted→COMMAND 1
When P1 and P2 are specified→COMMAND 2
<COMMAND 1>
1) Specify Flexible PAD for receiving
→
(ISDN Network MG-PRI/PRA)
0-36: Flexible PAD for receiving (default value: 0)
0: 0dB 21:
1: 1dB(LOSS) 22:
2: 2dB(LOSS) 23:
: :
:
18: 18dB(LOSS) 34:
19: 19dB(LOSS) 35:
20: 20dB(LOSS) 36:
send or receive might be 0 depending on the PAD
Note:
control setting.
2) Specify Flexible PAD for sending
→
(MG-PRI/PRA ISDN Network)
0-36: Flexible PAD for sending (default value: 0)
A command is executed, and the result is displayed.
<COMMAND 2>
A command is executed, and the result is displayed.
MG-PRI/PRA
-1dB(GAIN)
-2dB(GAIN)
-3dB(GAIN)
:
-14dB(GAIN)
-15dB(GAIN)
-16dB(GAIN)