NEC Univerge sv8500 Manual page 864

EXIT COMMAND
To exit the maintenance command
[Normal occasion]
MG-COT > EXIT
Finished!
value = 11 = 0xb
->
When the "exit" command is executed on the OS prompt (
Note:
press the CTRL + C keys simultaneously to display the OS prompt (
[When configuration data is changed]
MG-COT > EXIT
Configration data was changed.
**Don't power off in progress**
Y:Save and Exit.
N:Exit without saving.
C:Cancel
(Y/N/C):Y
Configration data has been saved.
->
The screen returns to the prompt of the maintenance command (MG-COT Card, in default) if any error oc-
Note:
curs when "Y" is selected after changing the configuration data.
MG-COT Card [SCA-6COTA/SCA-6COTC]
Line 1: Normal occasion.
Line 2: Result is shown.
Line 3: Display changes to the OS
→
), key operation turns unaccepted. In this case,
Line 7: Select Y to make the changed
Line 8: Result is shown.
Line 9: Display changes to the OS
VOL.2-611
prompt.
→
) again.
configuration data effective and
exit the maintenance command.
prompt.