NEC Univerge sv8500 Manual page 392

• When DHCP server is NOT used & DNS server is NOT used
Set the following data on 8LC Card.
• IP address and subnet mask of 8LC Card (own address)
• Host name of 8LC Card (*optional)
• IP address of Default Gateway
• IP Address, Port Number, and Host name of SIP server (*host name setting is optional)
• Communication speed of LAN interface
When the DHCP is set to "ENABLE", IP addresses assigned here cannot take effect. Be sure to assign
Note:
"SET DHCP DISABLE" before starting the IP address setting.
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 1:
tions" in INTRODUCTION of Installation Manual.
1. IP Address and Subnet Mask of 8LC Card
--- IP Address & Subnetmask set ---
Current IP Address: 0.0.0.0
Current Subnetmask: 255.255.255.0
Change IP Address & Subnetmask? [Y(change)/N(current)/Q(quit)]: Y
Input new IP Address: 10.41.1.100
Input new Subnetmask: 255.255.255.0
2. Host name of 8LC Card (*Host name setting is optional. Enter N if not required to set host name.)
--- Host Name set ---
Current Host Name: No Value
Is there the Host Name? [Y/N]: Y
Input new Host Name: mcsip.nec.com
Enter the host name in full-domain format.
Note:
3. Default Gateway IP Address
--- Default Gateway IP Address set ---
Current Default Gateway: 0.0.0.0
Change Default Gateway? [Y(change)/N(current)/Q(quit)]: Y
Input new Default Gateway: 10.41.1.254
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
VOL.2-139
Note 1