NEC Univerge sv8500 Manual page 923

• When DHCP server is NOT used & DNS server is NOT used
Set the following data on MG-COT Card.
• IP address and subnet mask of MG-COT Card (own address)
• IP address of Default Gateway
• IP address, Port Number, and Host name of SIP server
• Ethernet Speed
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 1:
tions" in INTRODUCTION of Installation Manual.
When the DHCP is set to "ENABLE", IP addresses assigned here cannot take effect. Be sure to assign
Note:
"SET DHCP DISABLE" before starting the IP address setting.
1. IP Address and Subnet Mask of MG-COT Card
--- IP Address & Subnetmask set ---
Current IP Address: 0.0.0.0
Current Subnetmask: 255.255.255.0
Change IP Address & Subnetmask? [Y(change)/N(current)/Q(quit)] :
Y
Input new IP Address : 10.41.1.100
Input new Subnetmask: 255.255.255.0
2. Default Gateway IP Address
--- Default Gateway IP Address set ---
Current Default Gateway: 0.0.0.0
Change Default Gateway? [Y(change)/N(current)/Q(quit)]: Y
Input new Default Gateway : 10.41.1.254
Note 1
VOL.2-670
MG-COT Card [SCA-6COTB]