NEC Univerge sv8500 Manual page 902

Reliability:
MIN Cost:
<When DIFFSERV is selected>
Priority:
Default settings (IP PRECEDENCE, Priority=6, Low Delay=OFF, Throughput=OFF, Reliability=OFF,
Note:
Min Cost=OFF) is applied when the check box is not clicked.
AIVCL: Assignment of IP Service Voice Control Data (LDM)
A LOC-ID:Location ID of the self-location [0-4095]
B LOC-ID:Location ID of the destination location [0-4095]
Setting of Jitter Buffer: Click the check box to assign the Jitter Buffer data.
JB_MIN:
JB_MAX: Jitter Buffer maximum value [0-30 (
Default settings (JB_MIN=1 (10 ms), JB_MAX=30 (300 ms)) is applied when the check box is not clicked.
Note:
Setting of Type of Service (Voice Packet): Click the check box to assign the ToS data for voice packet.
IP Precedence/DiffServ: Select either of the radio buttons.
<When IP Precedence is selected>
Precedence:
Low Delay:
Through Put:
Reliability:
MIN Cost:
<When DiffServ is selected>
DSCP:
Default settings (IP Precedence, Precedence=5, Low Delay=OFF, Throughput=OFF, Reliability=OFF,
Note:
Min Cost=OFF) is applied when the check box is not clicked.
Setting of Payload: Click the check box to assign the Payload data. Specify the Payload Type and Payload
Payload Type: Select one of the payload type in the combo box.
Payload Size:
•
If payload type G.711 is specified to more than two priorities in PRI1 through PRI4, assign different pay-
Note:
load size to each priority.
When payload types G.723.1 (5.3K → 6.3K) and G.723.1 (6.3K → 5.3K) are to be assigned on the same
•
terminal, specify the same value to the payload size of both types.
Place a checkmark to set High Reliability to ON.
Place a checkmark to set Cost Precedence to ON.
Specify the DiffServ Code Point in the range of 0-63.
Jitter Buffer minimum value [0-30 (
Specify the precedence in the range of 0-7 (low-high).
Place a checkmark to set Low Delay to ON.
Place a checkmark to set High Throughput to ON.
Place a checkmark to set High Reliability to ON.
Place a checkmark to set Cost Precedence to ON.
Specify the DiffServ Code Point in the range of 0-63.
Size in the order of priority 1 to 4 (PRI1 through PRI4).
•No data
•G.711
•G.729.a
→
•G.723.1 (5.3K 6.3K)
•G.723.1 (6.3K → 5.3K)
Select one of the payload size in the combo box according to the Payload Type.
•No data
•10 milliseconds
•20 milliseconds
•30 milliseconds
•40 milliseconds
•60 milliseconds
VOL.2-649
MG-COT Card [SCA-6COTB]
× 10 milliseconds)]
× 10 milliseconds)]