NEC Univerge sv8500 Manual page 1306

<When SIP Mode>
Assign the configuration data for MG(PRI) in SIP mode. About the configuration data for Proprietary Protocol
mode, refer to page 1048.
STEP 1: When the boot program is started, the initial display below is displayed on the screen.
The default of registration mode is SIP mode, therefore, the system will require a one-time password
for authentication at initial startup. Enter the same password with one entered in SIP server. As long
as you don't enter a one-time password, you cannot go to the next step.
DP OK
MG-ID: xxxxxx
Boot program version : SP3839 SH7751R CBOOT-1 PROG-A
[xx.xx.xx.xx]
Main program version : SP3884 MG PRI PROG-A [xx.xx.xx.xx]
H/W PKG information
DSP information
DSP information
Starting Boot program.....
--- Online program Initial start --- (wait for a while)
:
:(Omitted)
:
No One Time Password!!
Please input a one time password.
One Time Password : •••••
Erase start...
Erase OK!
Write start...
Write OK!
One time password setting succeeded.
: CA-CC00 001
: DSP-K-AC49kernel [xx.xx.xx.xx]
: DSP-P-AC490012ae3-S [xx.xx.xx.xx]
VOL.2-1053
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]