NEC Univerge sv8500 Manual page 413

MAINTENANCE COMMAND FOR 8LC Card
The Maintenance Console uses the commands listed in.
COMMAND No. SUB COMMAND
SETUP 1 SP
COMMAND No. SUB COMMAND
1 BURSTPATTERN
2 CH_ATTRIBUTE
3 CID_SEND_WAIT
4 CODEC_COEF
5 DEFAULTROUTE
6 DHCP
7 DNS_SW
8 DSP_ECFB
9 EC_TRAINING
10 FAXERRORDETECT
11 FAXRECVPAD
12 FAXSENDPAD
13 HC_TIMER
14 INTERFACE
15 IPADDRESS
16 MUSICTYPE
17 MW_LAMP
SET
18 ONE_TIME_PASS
19 OPEN
20 OWN_NAME
21 PAD
22 PRERINGING
23 RINGFREQ
24 SENDPAD
25 SIGNALING_PORT_NO
26 SIGNALING_QOS
27 SIPSV_IPADDRESS
28 SMOOTH_PAD
29 STARTPORT
30 STUTTERDT
31 SYNCRINGING
32 VLAN
33 WARNING_TONE
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
SETUP COMMAND
Setting Burst Ringer Pattern:
Setting Channel Attribute:
Setting Caller ID Send Wait Timer:
Setting CODEC Coefficiency:
Setting Default Gateway:
Setting DHCP:
Setting DNS Server:
Setting DSP echo canceller for FAX communication:
Setting Training feature mode of echo canceller:
Setting FAX enable timer:
Setting Fax receiver PAD value:
Setting Fax sender PAD value:
Setting Health Check Receive Timer
Setting the communication speed for LAN interface:
Setting IP Address and Net Mask of 8LC Card:
Setting Internal Music-on-Hold type:
Setting Message Waiting Lamp control type:
Setting One Time Password for security:
Setting Open/Reverse mode:
Setting Host Name of 8LC Card:
Setting default receiver PAD value:
Setting Pre-Ringing:
Setting frequency of Ringer:
Setting default sender PAD value:
Setting signaling port number for SIP:
Setting QoS for SIP signaling session:
Setting IP address, port number, and host name of SIP serv-
er:
Setting DSP smooth PAD mode:
Setting RTP Start Port:
Setting Stutter Dial Tone:
Setting Synchronous Ringer mode:
Setting VLAN:
Setting the Warning Tone for LAN failure:
VOL.2-160
FUNCTION
FUNCTION
REMARKS
REMARKS