NEC Univerge sv8500 Manual page 851

25. Setting VLAN
MG-COT > SET VLAN
Please enter a parameter.
VLAN_ID (1-4094) : 1
COS (0-7) : 0
VLAN setting succeeded.
The maximum number of VLAN is one.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
26. Setting the Warning Tone for LAN failure
MG-COT > SET WARNING_TONE P1
Warning Tone Control setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
27. Setting RVS mode (for Australia)
MG-COT > SET RVS_AUST
Reverse Watch (ROA/ROS): ROA
Reverse Watch (AU) setting succeeded
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
MG-COT Card [SCA-6COTA/SCA-6COTC]
Line 3: Line 3: Enter the VLAN_ID in
Line 4: Enter the COS in the range of 0-
Line 5: Result is shown.
Line 1: Specify the mode.
Line 2: Result is shown.
Line 2: Enter RVS mode
Line 3: Result is shown.
VOL.2-598
the range of 1-4094.
7.
0=Warning Tone is not sent
1=Warning Tone is sent to IP
Network
2=Warning Tone is sent to PSTN
3=Warning Tone is sent to IP
Network and PSTN (default)
ROA = Reversal on Answer
(default)
ROS = Reversal on Seizure