NEC Univerge sv8500 Manual page 1245

Δ
3. SHOW DRSADDRESS
This command is used to display the status of DRS.
COMMAND 1
MG-PRI> SHOW DRSADDRESS
Primary DRS Address
Secondly DRS Address
COMMAND 2
MG-PRI> SHOW DRSADDRESS 1
Primary DRS Address
Δ
4. SHOW DRSQOS
This command is used to display the QOS setting for DRS session. The following is an example in the case
of TOS setting.
MG-PRI> SHOW DRSQOS
DRS QoS is 0xC0. (QOS:TOS)
PRECEDENCE=6
DELAY=0
THROUGHPUT=0
RELIABILITY=0
COST=0
5. SHOW Δ DTMF_IN
This command is used to display Inband DTMF Relay feature.
MG-PRI > SHOW DTMF_IN
Inband DTMF Relay is OFF.
Δ
[P1]
10.41.1.100, Port 3456
10.41.1.101, Port 3457
10.41.1.100, Port 3456
VOL.2-992
P1-Select the status of DRS to be displayed. If omit-
ted, the status of all the DRSs are displayed.
1=Primary DRS
2=Secondary DRS
-When the DRS is specified, COMMAND1 is dis-
played.
-When the DRS is not specified, COMMAND2 is dis-
played.
The current setting is displayed.
- QOS
- PRECEDENCE (0-7 (low-high))
- Delay (0/1=Normal/Delay)
- THROUGHPUT (0/1=Normal/High Throughput)
- RELIABILITY (0/1=Normal/High Reliability)
- COST (0/1=Normal/Cost Precedence)
- DSCP (0-63)
The current setting is displayed.
MG-PRI/PRA