NEC Univerge sv8500 Manual page 1347

PRECEDENCE
DELAY
THROUGHPUT
RELIABILITY
COST
DRS QoS setting succeeded.(0xC0)
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
Note:
followed by the prompt. The meaning of 1-byte data in ToS field for IP Precedence is shown below:
Prec.
MG-PRI(SIP)>SET DRSQOS
QOS (TOS/DIFFSERV:TOS):DIFFSERV
DSCP(0-63:0):48
DRS QoS setting succeeded. (0xC0)
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
Note:
followed by the prompt. The meaning of 1-byte data in ToS field for Diffserv is shown below:
DSCP
When P1=TOS:
MG-PRI(SIP)>SET DRSQOS TOS 0xC0
DRS QoS setting succeeded.(0xC0)
When P1=DIFFSERV:
MG-PRI(SIP)>SET DRSQOS DIFFSERV 48
DRS QoS setting succeeded.(0xC0)
(0-7:6):6
(0/1:0):0
(0/1:0):0
(0/1:0):0
(0/1:0):0
D T R C
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
2) Specify precedence (Default: 6)
0-7 (low-high)
3) Select a type of delay (Default: 1)
0/1=Normal/Delay
4) Select a type of throughput (Default: 1)
0/1=Normal/High Throughput
5) Select a type of reliability (Default: 0)
0/1=Normal/High Reliability
6) Select a type of cost (Default: 0)
0/1=Normal/Cost Precedence
Result is displayed.
Prec.=PRECEDENCE (3 bits)
D=Delay
T=Throughput
R=Reliability
C=Cost
1) Specify DIFFSERV for QOS
2) Specify Diffserv Codepoint (DSCP)
Result is displayed.
DSCP = Differentiated Service Code Point (6 bits)
P2-Specify a value
0x02-0xFF (In the case of TOS)
Result is displayed.
P2-Specify a value
0-63 (In the case of DIFFSERV)
Result is displayed.
VOL.2-1094
0-63=DSCP