NEC Univerge sv8500 Manual page 846

14. Setting I/C call abandon timer
MG-COT > SET IC_ABANDON_TIME P1
I/C Call Abandon Timer setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
15. Setting the communication speed for LAN interface
MG-COT > SET INTERFACE
SPEED (AUTO/100M/10M) [AUTO] : 10M
DUPLEX (FULL/HALF) [HALF]
Ethernet Speed setting succeeded.
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
The DUPLEX setting is not shown when Auto Negotiation (AUTO) is selected in the Speed setting.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
16. Setting IP Address and Net Mask
MG-COT > SET IPADDRESS P1 P2
IP Address setting succeeded.
The designated IP address cannot be applied when the DHCP is set to Enabled. Assign the DHCP setting
Note:
to Disable before executing this IP address setting.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
: HALF
VOL.2-593
MG-COT Card [SCA-6COTA/SCA-6COTC]
Line 1: Enter the Incoming call abandon
timer (0-2).
0=6 seconds (default)
1=3 seconds
2=1 second
Line 2: Result is shown.
Line 2: Select the communication speed.
AUTO=Auto Negotiation (default)
100M=100 Mbps fixed mode
10M=10 Mbps fixed mode
Line 3: Select the Duplex mode.
FULL=Full Duplex mode
HALF=Half Duplex mode
Line 4: Result is shown.
Line 1: Enter the IP Address, then Subnet
Mask after a space.
Line 2: Result is shown.