NEC Univerge sv8500 Manual page 1227

Δ
14. SET MEDIAQOS
This command is used to specify Quality of Service (QOS) for Real-Time Protocol (RTP) session. To make
this assignment effective, it is required to execute the "SAVE" command and to restart before exiting the
maintenance command.
COMMAND 1
MG-PRI > SET MEDIAQOS
QOS (TOS/DIFFSERV:TOS):TOS
PRECEDENCE (0-7:0):6
DELAY (0/1:0):0
THROUGHPUT (0/1:0):0
RELIABILITY(0/1:0):0
COST (0/1:0):0
DRS QoS setting succeeded. (0xC0)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 2
MG-PRI > SET MEDIAQOS
QOS (TOS/DIFFSERV:TOS):DIFFSERV
DSCP(0-63:0):48
RTP QoS setting succeeded. (0xC0)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 3
MG-PRI > SET MEDIAQOS TOS 0xC0
RTP QoS setting succeeded. (0xC0)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 4
MG-PRI > SET MEDIAQOS DIFFSERV 48
RTP QoS setting succeeded. (0xC0)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
COMMAND 5
MG-PRI > SET MEDIAQOS CLEAR
RTP QoS clearing succeeded. (0x00)
In order to make a setup reflect, re-starting
is required after saving a configuration file
by SAVE command.
Δ Δ
[P1] [P2]
VOL.2-974
P1-Specify a type of services
TOS: IP Precedence
DIFFSERV: Differentiated Service
CLEAR: Clear the data
P2-Specify a value
00-FF (In the case of TOS)
0-63 (In the case of DIFFSERV)
When P2 is omitted (TOS selection)
→ COMMAND 1
When P2 is omitted (DIFFSERV selection)
→ COMMAND 2
When TOS in P1 and the settings in P2 are specified
→ COMMAND 3
When DIFFSERV in P1 and the settings in P2 are spec-
ified
→ COMMAND 4
When CLEAR is specified in P1
→ COMMAND 5
<COMMAND 1>
1) Specify precedence (Default: 5)
0-7 (low-high)
2) Select a type of delay (Default: 1)
0/1=Normal/Delay is ON
3) Select a type of throughput (Default: 1)
0/1=Normal/High Throughput ON
4) Select a type of reliability (Default: 0)
0/1=Normal/High Reliability ON
5) Select a type of cost (Default: 0)
0/1=Normal/Cost Precedence ON
A command is executed, and the result is displayed.
<COMMAND 2>
1) Enter the change effective timer
0=invalid to change to FAX mode
1-5=possible to change to FAX mode within 1-5
2) Specify Diffserv Codepoint
0-63=DSCP
A command is executed, and the result is displayed.
<COMMAND 3-5>
A command is executed, and the result is displayed.
MG-PRI/PRA