NEC Univerge sv8500 Manual page 901

Setting of PAD
PAD Information
The PAD value of MG (6COT) is valid only when you select "Setting"from the drop-down box of "Setting
Note:
of Detail" to specify the detail PAD value.
AIVCL: Assignment of IP Service Voice Control Data (LDM)
Assign the voice packet control data for terminal that is connected to MG (6COT).
A LOC-ID
B LOC-ID
SETTING OF JITTER BUFFER
SETTING OF TYPE OF SERVICE (VOICE PACKET)
SETTING OF PAYLOAD
ALOCL: Assignment of Location ID Data (LDM)
Each IP terminal is allocated a Location ID to identify its location within the network on Network Address
basis. By using the Location ID, IP services such as Bandwidth Control and ToS Control are provided for
each IP terminal. Select "Network Address" radio button in ALIDL command.
TYPE: Select "Network Address".
IP ADDRESS: Enter the IP Address. For the Telephony Server (IPPAD), assign "0.0.0.0".
MASK BIT: Enter the Mask Bit in the range of 1-31 except when IP Address 0.0.0.0 is determined. Mask
Bit=32 is automatically set when IP Address=0.0.0.0
NETWORK ADDRESS: Display only.
LOC-ID: Assign the Location ID in the range of 0-4095, associated with the IP Address. When IP Ad-
dress=0.0.0.0, LOC-ID=0 is automatically set (the value cannot be changed).
LOC-ID=0 is predetermined to the Location ID of the Telephony Server (i.e.IPPAD).
Note:
Setting Type of Signaling Packet Service: Click the check box to assign the ToS for signaling packet.
IP PRECEDENCE/DIFFSERV:
<When IP PRECEDENCE is selected>
Priority:
Low Delay:
Through Put:
SIZE
Click this check box when setting data for PAD value of MG.
This parameter is available only when the check box of "Setting of PAD" is ON.
No = 1: The PAD value of MG when DtermIP/Soft Phone/INASET is connected
No = 2: The PAD value of MG when Analog MC/Digital MC is connected
No = 3: The PAD value of MG when IPPAD is connected
No = 4: The PAD value of MG when MG is connected
Location ID of MG (6COT) or IP terminal
Location ID of MG (6COT) or IP terminal
JB_MIN:Jitter Buffer Minimum
JB_MAX:Jitter Buffer Maximum
Type of service for MG (6COT)
PAYLOAD TYPE
PAYLOAD SIZE
Specify the precedence in the range of 0-7 (low-high).
Place a checkmark to set Low Delay to ON.
Place a checkmark to set High Throughput to ON.
VOL.2-648
MG-COT Card [SCA-6COTB]