NEC Univerge sv8500 Manual page 423

SET COMMAND
1. Setting Burst Ringer Pattern:
MC(SIP)> SET BURSTPATTERN P1
Burst Ringer Pattern setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
2. Setting Channel Attribute:
MC(SIP)> SET CH_ATTRIBUTE P1
FAX PROTOCOL (OFF/T30/BYPASS)[OFF]: OFF
ECM (ON/OFF)[OFF]: OFF
FAX RATE (2400/4800/7200/9600/12000/
14400)[14400]: 14400
CH Attribute (CH00) setting succeeded.
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
P1: Select Ringer Pattern [1-5] (default=1)
1 = 0.35 seconds ON - 0.3 seconds OFF - 0.35 seconds ON
2 = 0.4 seconds ON - 0.2 seconds OFF - 0.4 seconds ON
3 = 0.2 seconds ON - 0.2 seconds OFF - 0.2 seconds ON -
4 = 0.2 seconds ON - 0.4 seconds OFF - 0.2 seconds ON -
5 = 0.25 seconds ON - 0.25 seconds OFF - 0.25 seconds
Result is shown.
VOL.2-170
0.2 seconds OFF - 0.2 seconds ON
0.2 seconds OFF
ON - 0.25 seconds OFF
P1: Enter the Line Number [0-7]
Select FAX protocol (default=OFF)
OFF = FAX protocol is set to OFF (default)
T30 = FAX Relay (T.30) is used
BYPASS = Data Transmission as voice
data
Enable/Disable ECM (Error Correction
Mode)
ON = ECM is valid
OFF = ECM is invalid (default)
Select maximum FAX speed
(default =14400)
Result is shown.