NEC Univerge sv8500 Manual page 898

<Related to MF>
CDN 72 MFSP
CDN 73 KPPT
CDN 74 KPST
CDN 75 MT
<Loop Start>
CDN 15 LSG = 0
To change the data for existing route (RT), initialize or reboot the trunk device such as circuit card, MG, or
Note:
VS-32.
ARTI: Assignment of Trunk Application Data
Assign Trunk Application Data for Virtual Speech Channel.
CDN68 VIR = 2
When using fax connection via MG, following assignment is necessary.
CDN 71 IP FAX data
CDN 72 Jitter Buffer Size for IP FAX
CDN 73 Payload Type for IP FAX
CDN 74 Payload Size for IP FAX
To change the data for existing route (RT), initialize or reboot the trunk device such as circuit card, MG, or
Note:
VS-32.
ATRK: Assignment of Trunk Data
Assign the Trunk Data for Virtual Speech Channel.
The example of data setting procedure is shown below.
Virtual trunk occupies 1HW (4-Group). For example, if one channel is registered for Virtual Trunk, the
Note:
whole HW is occupied exclusively for the Virtual Trunk.
Do not assign any trunk data to Group 0 of Unit 0 in even number Module group because it cannot be used
Note:
with MG-COT.
Sending Speed (0-15)
Duration of KP sending (0-15)
Pause after KP sending (0-15)
Step Code (0/1)
Loop Start is available
MG connection
VOL.2-645
MG-COT Card [SCA-6COTB]