NEC Univerge sv8500 Manual page 434

27. Setting IP address, port number, and host name of SIP server:
MC(SIP)> SET SIPSV_IPADDRESS
SIP Server (1-20): 1
IP Address [0.0.0.0]: 10.41.2.100
Port Number [5060]: 5060
Is there the Host Name? (Y/N) [N]: Y
Host Name: SVR1.nec.com
SIP Server setting succeeded.
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
•When DHCP setting is ENABLE, the specified IP address cannot be used. Execute "SET DHCP
Note:
DISABLE" before setting IP address.
•When DHCP setting is ENABLE or DNS setting is DISABLE, the specified host name cannot be used.
Execute "SET DHCP DISABLE" and "SET DNS_SW" before setting host name.
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 1:
tions" in INTRODUCTION of Installation Manual.
28. Setting DSP smooth PAD mode:
MC(SIP)> SET SMOOTH_PAD P1
Smooth PAD Mode setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
Enter the SIP server's number [1-20]
Up to 20 SIP servers can be used in one network.
Enter the IP address of SIP server Note 1
e.g. 10.41.2.100 (default=0.0.0.0)
Enter the port number [1024-65535] (default=5060)
Select whether to use host name [Y/N]
Enter the host name in the full-domain format, within 63-
byte of alphanumerics, ". (period)", and "- (hyphen)".
63. (*This line is displayed when "Y" is selected above.)
Result is shown.
VOL.2-181
P1: Enter a value of smooth PAD [1-5, OFF]
OFF=Set smooth PAD mode to OFF
1=2.0dBm (default)
2=-5.2dBm
3=-2.1dBm
4=0dBm
5=-4.2dBm
Result is shown.