NEC Univerge sv8500 Manual page 394

(4) Save the assigned configuration data at the last of SETUP SP command to complete network setting.
**Don't power off in progress**
Do you save the configuration data? [N/Y]:Y
Configuration data has been saved.
Restarting is required for making a setup reflect!!
Sp mode setting succeeded.
The register mode will be changed to
SP mode after re-starting
STEP 7: Use SHOW command to see all the required configuration data is correctly assigned.
STEP 8: Reboot the 8LC Card by turning the power OFF
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
→
VOL.2-141
ON or pressing RESET button.