6.3.2
Terminal Software Setting on Maintenance Console
STEP 1: Connect a PC (maintenance console) to CONSOLE connector.
STEP 2: Run terminal software (e.g. HyperTerminal) on the Maintenance Console.
STEP 3: Set the parameter of the terminal software as follows:
•
Port: COM1 (depending on PC setting)
•
Baud Rate: 9600 bps
•
Data: 8 bits
•
Parity: None
•
Stop Bit: 1
•
Flow Control: None
For the detailed procedure of Terminal Software (HyperTerminal) setting, refer to Vol.1, Chapter 2, "2. IP
Note:
Related Basic Programming" in this manual.
6.3.3
Power ON
STEP 1: Connect the Ground Cable to the Frame Ground (FG).
REAR VIEW
MC&MG
MUSIC
PFTRD
Ether
LINE 0 LINE 1
RS-232C
VOL.2-247
MC & MG with PFT
Contents
Static Sensitive
Handling
Precautions Required
to the FG
ATTENTION