•
When DHCP server is NOT used
Set the following data on MG(PRI) side.
•
DHCP Server Setting
MG-PRI> SET DHCP DISABLE
DHCP setting succeeded
•
IP address and subnet mask of MG(PRI)
MG-PRI> SET IPADDRESS 10.10.10.170 255.255.255.0
IP Address setting succeeded.
•
IP address of Default Gateway
MG-PRI> SET DEFAULTROUTE 10.10.10.255
Default Gateway setting succeeded.
•
IP address and port number of DRS
MG-PRI> SET DRSADDRESS
DRS Unit (1: Primary/2: Secondary/3: Tertiary/4: Fourth): 1
DRS IP Address: 10.10.10.30
DRS Port Number: 5060
DRS setting succeeded.
•
IP address of Default Gateway
MG-PRI> SET INTERFACE
SPEED (AUTO/100M/10M):AUTO
Ethernet Speed setting succeeded.
IP addresses assigned here are not effective when DHCP server is set to "Enabled". Be sure to assign "SET
Note 1:
DHCP DISABLED" before starting the IP address setting.
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 2:
INTRODUCTION of Installation Manual.
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
Note 1
Note 2
VOL.2-1051