NEC Univerge sv8500 Manual page 860

27. To show VLAN setting
MG-COT > SHOW VLAN
VLAN is ENABLE
DEVICE ID COS
VLAN1 1 0
28. To show Warning Tone control
MG-COT > SHOW WARNING_TONE
Warning Tone Control of IP Network is 3 (IP & TDM
side)
29. To show RVS mode (for Australia)
MG-COT> SHOW RVS_AUST
Reverse Watch (AU) is ROA.
30. To show E911 Connection Signal Detection Timer
MG-COT> SHOW CONNECT_TIME
E911 Connection Signal Detection Timer is 0.
31. To show E911Answer Signal Detection Timer
MG-COT> SHOW ANSWER_TIME
E911 Reception Signal Detection Timer is 0.
32. To show Auto Polarity
MG-COT> SHOW AUTO_POLARITY
Auto Polarity is ON.
IPADDRESS SUBNETMASK
0.4.128.5 255.255.255.0
VOL.2-607
MG-COT Card [SCA-6COTA/SCA-6COTC]
The current VLAN setting is shown.
The current setting is shown.
The current setting is shown.
The current setting is shown.
The current setting is shown.
The current setting is shown.