NEC Univerge sv8500 Manual page 1363

Δ
26. SET RTP_STOP_DETECT
This command is used to specify a time-out value as one of the conditions for MG Based Call Retention to
determine that the call is released. The call will be determined released if RTP is not received exceeding
the assigned time-out value during call retention. To make this assignment effective, it is required to exe-
cute the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET RTP_STOP_DETECT 3
RTP Stop Detect Timer setting succeeded.
Δ
27. SET SIGNALING_PORT_NO
This command is used to specify
is required to execute the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET SIGNALING_PORT_NO 65535
Signaling port number setting succeeded.
Δ
28. SET SIGNALING_QOS
This command is used to specify the type of Quality of Service (QoS), which can be selected in Type of
Service (TOS) or Differentiated Service (DIFFSERV) either. To make this assignment effective, it is re-
quired to execute the "SAVE" command and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET SIGNALING_QOS TOS 0xC0
Signaling QoS setting succeeded.(0xC0)
When P1 and P2 are omitted (When TOS is selected)
MG-PRI(SIP)>SET SIGNALING_QOS
QOS(TOS/DIFFSERV: TOS):TOS
PRECEDENCE (0-7:6): 6
DELAY (0/1: 0): 0
THROUGHPUT (0/1: 0): 0
Δ
P1
Δ
P1
a port number to be used for PHI-PRI
Δ Δ
P1 P2
VOL.2-1110
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
P1-Specify the time-out value for RTP recep-
tion.
3-32 seconds (default: 3 seconds)=Effective
range
Result is displayed.
. To make this assignment effective, it
P1-Specify a port number to be used for PHI-
PRI.
1024-65535=Port Number (Default: 5060)
Result is displayed.
P1-Specify the type of QoS.
TOS=IP Precedence type.
DIFFSERV=DIFFSERV type
CLEAR=Clear the current setting
P2-Specify a value of QoS directly.
0x00-0xFF=ToS value
0-63=DIFFSERV value
Result is displayed.
Specify the precedence in IP network.
0-7=the precedence in IP network (Default:6)
Enable/Disable Low Delay Precedence in IP network.
0=Disabled (Default)
1=Enabled
Enable/Disable Throughput Precedence in IP network.
0=Disabled (Default)
1=Enabled