NEC Univerge sv8500 Manual page 955

24. Setting RTP Start Port
MG-COT > SET STARTPORT P1
RTP Start Port Number setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
Port number must be the even number. RTCP port number is assigned to start port number + 1. (odd num-
Note:
ber)
25. Setting VLAN
MG-COT > SET VLAN
Please enter a parameter.
VLAN_ID (1-4094) : 1
COS (0-7) : 0
VLAN setting succeeded.
The maximum number of VLAN is one.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
26. Setting the Warning Tone for LAN failure
MG-COT > SET WARNING_TONE P1
Warning Tone Control setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
27. Setting Auto Polarity
MG-COT > SET AUTO_POLARITY P1
Auto Polarity setting succeeded.
Line 1: Enter the number of RTP Start
Line 2: Result is shown.
Line 3: Line 3: Enter the VLAN_ID in
Line 4: Enter the COS in the range of 0-
Line 5: Result is shown.
Line 1: Specify the mode.
Line 2: Result is shown.
Line 1: Specify the auto polarity.
Line 2: Result is shown.
VOL.2-702
MG-COT Card [SCA-6COTB]
Port in the range of 1024-64510
(default=1024).
the range of 1-4094.
7.
0=Warning Tone is not sent
1=Warning Tone is sent to IP
Network
2=Warning Tone is sent to PSTN
3=Warning Tone is sent to IP
Network and PSTN (default)
OFF = Invalid (default)
ON = Valid