NEC Univerge sv8500 Manual page 842

5. Setting IP address and port number of DRS
MG-COT > SET DRSADDRESS
DRS Unit (1:Primary/2:Secondary/3:Tertiary/
4:Forth) : 1
DRS IP Address [0.0.0.0] : 150.10.1.100
DRS Port Number (1024-65535) [3456] : 3456
DRS setting succeeded.
The designated DRS setting cannot be applied when SP mode. Assign the Proprietary Protocol mode before
Note:
executing this DRS setting.
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 1:
INTRODUCTION of Installation Manual.
6. Setting ToS of DRS session
MG-COT > SET DRSTOS PRECEDENCE
PRECEDENCE (0-7) : 6
DELAY (0/1) : 0
THROUGHPUT (0/1) : 0
RELIABILITY (0/1) : 0
COST (0/1) : 0
DRS TOS setting succeeded.(0xC0)
MG-COT Card [SCA-6COTA/SCA-6COTC]
Line 2: Select "1" for the Telephony
Line 3: Enter IP Address of DRS. (e.g.
Line 4: Enter Port Number of DRS
Line 5: Result is shown.
Line 1: Enter sub command name
Line 2: Precedence:0-7(low-
Line 3: Delay:0/1=Nomal(default)/Low
Line 4: Throughput:0/
Line 5: Reliability:0/1=Nomal(default)/
Line 6: Cost:0/1=Nomal(default)/Cost
Line 7: Result is shown.
VOL.2-589
Server in normal condition.
150.10.1.100) Note 1
(1024-65535, default = 3456).
PRECEDENCE to set the
parameters such as Delay,
Throughput, Reliability, and
Cost. Specify the value to each
parameter.
high)(default=6)
Delay ON
1=Nomal(default)/High
Throughput ON
High Reliability ON
Precedence ON