NEC Univerge sv8500 Manual page 937

SETUP COMMAND
1. Set up network environment for MG-COT Card Proprietary Protocol mode.
This command is used to setup the basic data for Proprietary Protocol mode. Setting display differs whether
DHCP server is used or not. Assign the required network data following the setting command shown in
dialog form. Be sure to save the entered data at the last of SETUP command.
The designated operating status cannot refer when SP-3948 6MG COT PROG-A Ver.1.0.0.0 or later.
Note:
• When DHCP is used:
MG-COT > setup tp
MG-ID = xx:xx:xx:xx:xx:xx
Use DHCP?
Input (Y:Yes / N:No / Q:Quit) : y
--------------------------------------
MG-ID = xx:xx:xx:xx:xx:xx
DHCP = ENABLE
--------------------------------------
Input (Y:OK / N:Change / Q:Quit) : y
** Don't power off in progress **
Do you save the configuration data? (Y/N) : y
Configuration data has not been saved.
Re-starting is required for making a setup
reflect!!
Tp mode setting succeeded.
The register mode will be changed to
TP mode after re-starting.
MG-COT >
If DHCP server is set for use, DHCP Option will be set for use automatically. If you do not assign the IP
Note:
address of DRS to DHCP server, It must be assigned by "SET DRSADDRESS" command individually.
MAC Address is displayed.
Enter "y".
Enter "y" when the assigned data is cor-
rect.
Enter "y" when saved the configuration
data.
Result is shown.
VOL.2-684
MG-COT Card [SCA-6COTB]