NEC Univerge sv8500 Manual page 1357

Δ
21. SET PRI_COMMON1
This command is used to specify common data 1 for PRI (1.5M). When not specifying an attribute on the
interactive setting, the original setting keeps being used. To make this assignment effective, it is required
to execute the "SAVE" command and to restart before exiting the maintenance command.
When P1 is not entered:
MG-PRI(SIP)>SET PRI_COMMON1
Remote Alarm Sending
Signal All 1
Idle Code Sending
Dch Back-up
Layer 1 Alarm Sending
Haul Mode
EC NLP Control
EC NLP Mode
EC 2100Hz Detect
Music Int/Ext
Music No.
Clock Mode
Layer1 Alarm Display
set value is 0x0215
setting succeeded.
Δ[
P1]
1) Disable/Enable Remote Alarm Sending
(0/1:0):0
2) Disable/Enable Signal All
(0/1:0):0
3) Disable/Enable Idle Code Sending
(0/1:0):0
4) Disable/Enable Dch Back-up
(0/1:0):0
5) Disable/Enable Layer 1 Alarm Sending
(0/1:0):0
6) Disable/Enable Haul Mode
(0/1:0):0
7) Disable/Enable EC NLP Control
(0/1:1):1
8) Specify EC NLP Mode
(0/1:0):0
9) Disable/Enable EC 2100Hz Detect
(0/1:0):0
10) Select Music Source
(0/1:0):0
11) Specify Music-on-Hold
(0-12:5):5
12) Specify clock mode
(0/1:0):0
13) Disable/Enable Layer 1 Alarm LED display
(0/1:1):1
Result is displayed.
VOL.2-1104
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
0/1=Enable(default)/Disable
0/1=Disable(default)/Enable
0/1=Disable(default)/Enable
0/1=Disable(default)/Enable
0/1=Enable(default)/Disable
0=Short (default)
1=Long
0/1=Disable/Enable (default)
0=Background Noise (default)
1=Fixed Level
0/1=Disable(default)/Enable
0=Internal (default)
1=External
0=For Elise
5=Minuet (default)
0=Secondary (default) *for user mode
1=Primary *for network mode
0/1=Enable/Disable (default)