Mcmg [Sca-7Cota] - NEC Univerge sv8500 Manual

8.1.4 Requirements
1. Hardware Requirements
To use the MCMG for an analog terminal and PSTN connection, the following hardware is required:
• PC running Terminal Software (for Maintenance Console)
• Cables
LAN cable:
Line Cable:
CONSOLE Cable:
Audio Cable:
2. Firmware Program
The following program is installed in MCMG [SCA-7COTA].
• Installed Firmware: SP-3849 MCMG PROG-A
3. Environmental Requirements
°
• Temperature: 0
• Humidity: 20%~90% (not condensing)
• Main Source Power: AC100V/120V/230/240V (50/60 Hz)
Use any of the following cables for connecting to LAN.
10BASE-T:Unshielded Twisted-pair (UTP) Straight-through Cable Category 3 or
higher, (a maximum of 100 m)
100BASE-TX:Unshielded Twisted-pair (UTP) Straight-through Cable Category 5
or higher, (a maximum of 100 m)
For the connection between an Analog Terminal and an MC, use a Modular Cable
with an RJ-11 Modular Jack.
For the connection to PSTN network, use a Modular Cable with an RJ-11 Modular
Jack.
RJ-45 ⇔ RS-232C serial cable (for maintenance console)
Microphone Input (for external Music-On-Hold source)
3.5 φ mini-jack (monaural type)
° ° °
C~40 C (32 F~104 F)
VOL.2-416
MCMG Card [SCA-7COTA]
± 10%