NEC Univerge sv8500 Manual page 841

2. Setting Default Gateway
MG-COT > SET DEFAULTROUTE P1
Default Gateway setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
3. Setting DHCP
MG-COT > SET DHCP P1
DHCP setting succeeded.
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
4. Setting DNS Server
MG-COT(SIP)> SET DNS_SW
DNS Interface (ENABLE/DISABLE) [ENABLE]: ENABLE
DNS IP Address [0.0.0.0]: 10.41.2.101
DNS setting succeeded.
The designated DNS Server cannot be applied when Proprietary Protocol mode. Assign the SP mode before
Note:
executing this DNS Server setting.
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
When DISABLE is selected, the setting line of DNS IP Address is not displayed.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
MG-COT Card [SCA-6COTA/SCA-6COTC]
Line 1: Enter Default Gateway Address.
Line 2: Result is shown.
Line 1: Enter ENABLE or DISABLE
Line 2: Result is shown.
Line2: ENABLE=DNS server is used
Line3: Enter the IP address of DNS
Line 4: Result is shown.
VOL.2-588
after the command name.
ENABLE=DHCP is valid
(default), DISABLE=DHCP is
invalid.
DISABLE=DNS server is not
used (default)
server (e.g. 10.41.2.101)