NEC Univerge sv8500 Manual page 1067

12.3.1 Data Assignment by PCPro
This section explains the data assignment procedures to the Telephony Server by PCPro.
[1] Internal PHE Data Assignment
MG(BRI) is registered to SP-PHI. In this case, MPH is used to control SP-PHI. For the use of MPH, it is required
to make Internal PHE function valid. So Internal PHE data assignment is necessary. About the procedure for the
Internal PHE data assignment, refer to Vol.1, Chapter 2, "2. IP Related Basic Programming" in this manual. The
explanation of PHs including Internal PHE is also there.
[2] SP-PHI Data Assignment
MG(BRI) is registered to SP-PHI. So SP-PHI data assignment is necessary. About the procedure for the SP-PHI
data assignment, refer to Vol.1, Chapter 2, "2. IP Related Basic Programming" in this manual. The explanation
of PHs including SP-PHI is also there.
[3] MG(BRI) Data Assignment
Assign the necessary System Data for using MG(BRI).
ASYD (Assignment of System Data)
SYS1
INDEX 64, b0: 0/1=
INDEX 186, b6=1 (ISDN is in service)
INDEX 187=00 (Fixed)
INDEX 474 Guard Timer for Originating Call (MTC
bit 0-3: MTC (Timer Counter)
bit 4-6: TC (Timer Class), assign 1H (64 milliseconds)
ASYDL (Assignment of System Data for LDM)
SYS1
INDEX 810, b2: 0/1=Internal Music-on-Hold of IP terminal/External Music-on-Hold
INDEX 811: Tone Code (depends on the country). For more information, refer to the Command Manual.
INDEX 818, b6=1 (ETSI ISDN is supported)
INDEX 824, b4: 0/1=EC training feature of MG disabled/enabled
Effective only when nothing is assigned for AMGIL command.
Note 1:
Effective when Interface type of Route Class Data is INT: 6. Assign this system data only for Australia.
Note 2:
ARTD (Assignment of Route Class Data)
Assign the Route Class Data of Virtual Speech Channel.
CDN65 (INT):
CDN60 (TC/EC): 1 (TC)
CDN114 (DCH): 1 (Channel Integration Enabled)
μ -law/A-law of CODEC (depends on the country)
Interface Specification for ISDN
VOL.2-814
× TC)
Note 2
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Note 1