NEC Univerge sv8500 Manual page 616

Enter the command, sub command and required parameters after the prompt (MC-MG>) appears. Parameters
vary depending on the kind of command specified. When the data (command name, sub command name, pa-
rameter) are specified correctly, the command executes the required data processing, and then displays the pro-
cessed result on the screen. To finish this program, input EXIT after a prompt.
When the maintenance command program is activated, it provides a Help Function for referring to avail-
Note:
able commands and sub commands. After a prompt is shown, request to list-up the Target Help by entering
"?" or "command name (SET or SHOW) + ?", and press the Enter key.
The example below shows the screen when requesting a list of SET commands.
MC-MG> SET ?
BURSTPATTERN
CH_ATTRIBUTE
DEFAULTROUTE
DHCP
DRSADDRESS
:
:
Setting Burstpattern
Setting CH attribute
Setting Default Gateway
Setting DHCP
Setting DRS Address
VOL.2-363
MCMG [SCA-4LC2COTA/MG-4LC2COTA]