NEC Univerge sv8500 Manual page 488

Fp85-110 s7
Hide thumbs Also See for Univerge sv8500:
Table of Contents

Advertisement

LOC-ID:
Assign the Location ID in the range of 0-4095, associated with the IP Address. When IP Ad-
dress=0.0.0.0, LOC-ID=0 is automatically set (the value cannot be changed).
LOC-ID=0 is predetermined to the Location ID of the Telephony Server (i.e.IPPAD).
Note:
Setting Type of Signaling Packet Service: Click the check box to assign the ToS for signaling packet.
IP PRECEDENCE/DIFFSERV:
<When IP PRECEDENCE is selected>
Priority:
Low Delay:
Through Put:
Reliability:
MIN Cost:
<When DIFFSERV is selected>
Priority:
Default settings (IP PRECEDENCE, Priority=6, Low Delay=OFF, Throughput=OFF, Reliability=OFF,
Note:
Min Cost=OFF) is applied when the check box is not clicked.
AIVCL: Assignment of IP Service Voice Control Data (LDM)
A LOC-ID:Location ID of the self-location [0-4095]
B LOC-ID:Location ID of the destination location [0-4095]
Setting of Jitter Buffer: Click the check box to assign the Jitter Buffer data.
JB_MIN:
JB_MAX: Jitter Buffer maximum value [0-30 (
Default settings (JB_MIN=1 (10 ms), JB_MAX=30 (300 ms)) is applied when the check box is not clicked.
Note:
Setting of Type of Service (Voice Packet): Click the check box to assign the ToS data for voice packet.
IP Precedence/DiffServ: Select either of the radio buttons.
<When IP Precedence is selected>
Precedence:
Low Delay:
Through Put:
Reliability:
MIN Cost:
<When DiffServ is selected>
DSCP:
Default settings (IP Precedence, Precedence=5, Low Delay=OFF, Throughput=OFF, Reliability=OFF,
Note:
Min Cost=OFF) is applied when the check box is not clicked.
Setting of Payload: Click the check box to assign the Payload data. Specify the Payload Type and Payload
Payload Type: Select one of the payload type in the combo box.
Specify the precedence in the range of 0-7 (low-high).
Place a checkmark to set Low Delay to ON.
Place a checkmark to set High Throughput to ON.
Place a checkmark to set High Reliability to ON.
Place a checkmark to set Cost Precedence to ON.
Specify the DiffServ Code Point in the range of 0-63.
Jitter Buffer minimum value [0-30 (
Specify the precedence in the range of 0-7 (low-high).
Place a checkmark to set Low Delay to ON.
Place a checkmark to set High Throughput to ON.
Place a checkmark to set High Reliability to ON.
Place a checkmark to set Cost Precedence to ON.
Specify the DiffServ Code Point in the range of 0-63.
Size in the order of priority 1 to 4 (PRI1 through PRI4).
•No data
•G.711
•G.729.a
•G.723.1 (5.3K
6.3K)
•G.723.1 (6.3K
5.3K)
VOL.2-235
×
10 milliseconds)]
×
10 milliseconds)]
MC & MG with PFT

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents