NEC Univerge sv8500 Manual page 396

5.3.6 Basic Test Procedures
[1] Basic Connection Test
START
1. Is the PWR Lamp lighting green?
NO
Is the Power Cable firmly connected? Is the Power Switch turned ON?
YES
2. Is the LINK Lamp lighting green?
NO
The 8LC Card may not be physically connected to the LAN. Check the LAN Cable between 8LC Card
and Network Device.
Use a LAN Cable (straight-through).
YES
Test the continuity in the LAN Cable.
Make sure the network device (SW HUB or Router) is turned ON.
If the problem is not cleared, change the LAN Cable or change the network device.
*Initial setting on 8LC Card is started.
*Registration established.
*Initial setting between 8LC Card and Telephony Server.
*8LC Card starts operating normally.
3. Is the ON LINE Lamp lighting green?
NO
Check the data assignment on Telephony Server and 8LC Card.
- Telephony Server: Is the data assignment on each PCPro command correct?
- 8LC Card: Check the configuration data assigned from the maintenance console.
YES
A
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
VOL.2-143