NEC Univerge sv8500 Manual page 415

COMMAND
SAVE CONFIGDATA
COMMAND
GET CONFIGDATA
COMMAND
PUT CONFIGDATA
COMMAND
INIT CONFIGDATA
COMMAND
REBOOT -
COMMAND
EXIT -
Enter the command, sub command and required parameters after the prompt (MC(SIP)>). Parameters vary de-
pending on the kind of command specified. When the data (command name, sub command name, parameter) is
specified correctly, the command executes the required data processing, and then displays the processed result
on the screen. To finish this program, enter EXIT after a prompt.
When the maintenance command program is activated, it provides a Help Function for referring to avail-
Note:
able commands and sub commands. After a prompt, request to list-up the Target Help by entering "?" or
"command name (SET or SHOW) + ?", and press the Enter key.
The example below shows the screen when requesting a list of SET commands.
MC(SIP)> SET?
OWN_NAME
IPADDRESS
DEFAULTROUTE
SIGNALING_PORT_NO
SIPSV_IPADDRESS
:
:
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
SUB COMMAND
To save the configuration data to Flash ROM:
SUB COMMAND
To download Configuration Data file from specified TFTP
server:
SUB COMMAND
To upload Configuration Data file to specified TFTP server:
SUB COMMAND
To initialize the configuration data to factory default value:
SUB COMMAND
To reboot the 8LC Card:
SUB COMMAND
To exit the configuration command:
Setting Own Host Name
Setting IP Address
Setting Default Gateway
Setting Signaling Port
Setting SIP Server IP Address & Port Number & Host Name
FUNCTION
FUNCTION
FUNCTION
FUNCTION
FUNCTION
FUNCTION
:
:
VOL.2-162
REMARKS
REMARKS
REMARKS
REMARKS
REMARKS
REMARKS