NEC Univerge sv8500 Manual page 512

The user input command above consists of a several components. The following describes these components
using one of the SET commands.
MC-MG> SET IPADDRESS 123.201.18.45 255.255.255.0
1
1: Command
2: Sub Command
3: Parameter 1
4: Parameter 2
The number of parameters to be specified is different depending on the command.
Note:
In SET command, some of the sub commands can be specified with hexadecimal numbers (called Set Value),
which determine a group of the detailed values. It is also possible to omit its parameters; the interactive guidance
will help you specifying its detailed values. The following shows this patterns:
MAINTENANCE COMMAND FOR MC&MG
The Maintenance Console uses the commands listed in the table below.
COMMAND No. SUB COMMAND
1 DEFAULTROUTE
2 DHCP
3 DRSADDRESS
4 DRSTOS
SET
5 HC_TIMER
(both MC and
6 INTERFACE
MG sides)
7 IPADDRESS
8 STARTPORT
9 VLAN
10 WARNING_TONE
2 3
Setting Default Gateway
Setting DHCP
Setting DRS Address
Setting ToS of DRS session
Setting Health Check Receive Timer
Setting communication speed for LAN interface
Setting IP Address and Subnet Mask
Setting RTP Start Port number
Setting VLAN
Setting Warning Tone control
4
FUNCTION
VOL.2-259
MC & MG with PFT
REMARKS