NEC Univerge sv8500 Manual page 1138

RTP Start Port Number set
Assign the RTP start port number.
--- RTP Start Port Number set ---
Current RTP Start Port Number: 1024
Change RTP Start Port Number Port Number? [Y
(change)/N (current)/Q(quit)]: y
Input new RTP Start Port Number (1024-65512): 1024
Assign any even-numbered port number to the RTP start port. The specified data + 1 (the next odd-num-
Note:
bered port number) is assigned as the RTCP port number.
24 ports are occupied following the RTP start port. More than 24 of consecutive vacant ports must be re-
Note:
served from the specified port number to the last 65535.
Signaling QOS set
Assign the ToS data added to signaling session.
--- Signaling QOS set ---
Current Signaling QOS: IP Precedence [0xC0]
Change Signaling QOS? [Y (change)/N (current)/Q(quit)]: y
QoS [I (IP PRECEDENCE)/D (DIFFSERV): IP PRECEDENCE]:d
Current data setting is displayed.
Asked whether to change the displayed data.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
Enter the first port number to be used for RTP.
Port number: 1024~65512
(default = 1024)
VOL.2-885
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Current data setting is displayed.
Asked whether to change the displayed data.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
Select the QoS type.
I: IP Precedence
D: DIFFSERV