NEC Univerge sv8500 Manual page 1343

Change DRS Information? [Y (change)/N (current)/
Q(quit)]: Y
Input DRS unit (1:Primary/2:Secondary/3:Tertiary
/4:Fourth):1
Input DRS IP Address :10.41.1.200
Input DRS Port Number :3456
Continue? [Y (continue)/N (exit)]: N
--- Ethernet Speed set ---
Current LAN Speed: auto
Change LAN Speed? [Y (change)/N (current)/Q(quit)]: Y
Input new Speed [1 (AUTO)/2 (100M)/3(10M)]: 2
Input new DUPLEX [F (full)/H (half)]: F
** Don't power off in progress **
Do you save the configuration data? [Y/N] :Y
Configuration data has been saved.
Re-starting is required for making a setup reflect!!
TP mode setting succeeded.
About IP address of DRS (Telephony Server), refer to "Registration Destination of IP Devices/Stations" in
Note 1:
INTRODUCTION of Installation Manual.
The following are examples that cannot be set in the MG(PRI) setting:
Note:
(Example1) Network address cannot be assigned as IP address of MG(PRI).
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
VOL.2-1090
8) Select the DRS setting.
Y: Change the setting
N: Remain the current setting
Q: Exit the command
9) Select the applying type for DRS.
1=Primary
2=Secondary
3=Tertiary
4=Fourth
10) Specify the IP address of the
DRS. Note 1
11) Specify the port number of the
DRS.(Default:3456)
12) Select whether you continue to
set up the SIP Server or not.
Y: Continue the SIP Server setting
N: Exit the SIP Server setting
The current setting is displayed.
13) Select the LAN setting.
Y: Change the setting
N: Remain the current setting
Q: Exit the command
14) Select the LAN speed.
1: Auto Negotiation (Default)
2: 100Mbps
3: 10Mbps
15) Select the LAN mode.
F: Full Duplex mode
H: Half Duplex mode
* This is not displayed when Auto
Negotiation is selected.
16) Select whether you save the
configuration data or not.
Y: Save the configuration data
N: Do not save the configuration
data
Result is displayed.