NEC Univerge sv8500 Manual page 696

ASYDL: Assignment of System Data (LDM)
SYS1, INDEX 811
Assign the Tone Code by countries. For more information, refer to the Command Manual.
SYS1, INDEX 813
Assign the PAD value of MC
00 = No PAD control (conforms to the setting on ASYD, SYS1, INDEX 4, b5)
01 = PAD OFF (0dB)
02 = 3dB
03 = 6dB
AUNT: Assignment of Unit Data
MG: Module Group Number
TYPE: 1 (Select 1 for Unit data assignment)
UNIT0: 1/2 (Unit 0 is used/not used).
UNIT1: 1/2 (Unit 1 is used/not used).
UNIT2: 1/2 (Unit 2 is used/not used).
UNIT3: 1/2 (Unit 3 is used/not used).
ANPD: Assignment of Numbering Plan
1st DC: Assign the 1st DC of the station numbers.
NND: Assign the total station number digits.
ASPA: Assignment of Special Access Code
ACC: Assign the access code using the 1st DC specified by the ANPD command.
ATNR: Assignment of Tenant Restriction Class Data
Assign the Connection Restriction Data between Originating Tenant (OGTN) and Terminating Tenant
(TMTN). When ASYD, SYS1, INDEX 94, b0=0 is assigned (Multiple Tenant Service is in-service), assign
the respective Tenant Number of OGTN and TMTN. If not (when the data is "1"), assign the fixed Tenant
Number of "1" for both OGTN and TMTN.
TRI: "0" for Station-to-Station Calling
OGTN: Number of Originating Tenant
TMTN: Number of Terminating Tenant
RES: "0" for restriction/"1" for permission
For a Station-to-Outgoing Trunk Connection, allow the Route Restriction for each trunk by the ARSC com-
Note:
mand.
AISTL: Assignment of IP Station Data (LDM)
VOL.2-443
MCMG Card [SCA-7COTA]