NEC Univerge sv8500 Manual page 1080

• When DHCP Server is Disabled
The following listed items need to be assigned on MG(BRI).
• IP address of DNS server
• IP Address and Subnetmask of MG(BRI)
• Host Name of MG(BRI)
• IP address of Default Gateway
• IP address and Port Number of SIP server
• Host name of SIP server
• Ethernet Speed
• Signaling Port Number
• RTP Start Port Number
• Signaling QOS
• VLAN
IP addresses assigned here are not effective when DHCP server is set to "Enabled." Confirm to set DHCP
Note:
server to "Disabled" before setting these IP Addresses.
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 1:
tions" in INTRODUCTION of Installation Manual.
1. IP address of DNS server
--- DNS IP Address set ---
Current DNS IP Address: 0.0.0.0
Change DNS IP Address? [Y (change)/N (current)/Q(quit)]: y
Input new DNS IP Address: 10.40.1.150
2. IP Address and Subnetmask of MG(BRI)
--- IP Address & Subnetmask set ---
Current IP Address: 0.0.0.0
Current Subnetmask: 0.0.0.0
Change IP Address and Subnetmask? [Y (change)/N
(current)/Q(quit)]: y
Input new IP Address: 10.40.1.100
Input new Subnet mask: 255.255.255.0
Do not assign the following addresses (network address, broadcast address) to MG(BRI).
Note:
(example)
- IP address 192.168.1.0/Subnet mask 255.255.255.0 (192.168.1.0 is network address, improper)
- IP address 176.16.0.0/Subnet mask 255.255.0.0 (176.16.0.0 is network address, improper)
- IP address 192.168.1.255/Subnet mask 255.255.255.0 (192.168.1.255 is broadcast address, improper)
- IP address 176.16.255.255/Subnet mask 255.255.0.0 (176.16.255.255 is broadcast address, improper)
(*only when DNS server is used)
(*can be skipped when DNS server is not used)
(*only when DNS server is not used)
VOL.2-827
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Note 1
Current data setting is displayed.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
Enter the IP address of DNS server.
Current data setting is displayed.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
Enter the IP address of MG(BRI).
Enter the Subnet Mask of MG(BRI).