NEC Univerge sv8500 Manual page 410

Permit read behavior of this directory. For more information, refer to the appropriate manual
STEP 2
attached to the FTP server program.
<Data Assignment on PCPro>
Activate the ATDL command, and then specify the following:
STEP 3
Select an item of External Server in FTP Server Setup.
Input the IP address of FTP server.
Input Login Name and Password for logging in to FTP server if required.
Check an item of Parallel in Download Method.
After completing the above, click the Insert button.
Select Specify Terminal Type in How to Specify Terminal, and then select 8LC Card.
STEP 4
Click the Search button.
STEP 5
After the 8LC Cards are displayed in Result of Search, select the appropriate 8LC Card to be
STEP 6
upgraded the firmware.
If you narrow them down by specifying Terminal Type in the ATDL command, 8LC Cards will be displayed
Note:
per registered channel. 8LC Card is capable of eight channels, therefore, when those channels are being
used in an 8LC Card, the same 8LC Card is displayed eight times in the box. To avoid setting upgrade task
to the target 8LC Card eight times, select either one of the channels used in the 8LC Card by checking
LENS.
Click the Close button to go back to the main screen.
STEP 7
Click the Exe button to upgrade the firmware to the target 8LC Cards.
STEP 8
"Upgrade is succeeded" is displayed. Note that version information in the screen is not updat-
ed at this time. If the upgrade is failed, click the Close button, and then go back to STEP3.
After upgrade is completed, click the Close button. In the main screen, click the Exit button to
STEP 9
close the ATDL command.
To confirm the firmware, activate the DIPI command.
STEP 10
Select SIP Media Converter in Functionality Type, and then click the Execute button.
STEP 11
Confirm that the firmwares in the appropriate ones are upgraded.
STEP 12
<Confirmation of 8LC Card>
To confirm 8LC Card is operating properly with the upgraded firmware, make a call to the
STEP 13
8LC Card. Check that you can hear RBT.
Receive a call via the 8LC Card, and confirm that you can talk to each other.
STEP 14
After all the tasks are completed, write down/label the firmware version in the front of the
STEP 15
8LC Card. For example, 2A is indicated for Version 2. 3A is indicated for Version 3.
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
VOL.2-157