14.4.5 How to Use Maintenance Command
Configuration command is used just for modifying the default data. Data is to be modified only when it is re-
quired and to the necessary part.
"SIP server" used in this section refers to the Telephony Server. When MG(PRI) works in SIP mode, the
Note:
Telephony Server acts as SIP server.
"DRS (Device Registration Server)" used in this section refers to the Telephony Server. When MG(PRI)
Note:
works in Proprietary Protocol mode, the Telephony Server acts as DRS, which is controlling function of the
Telephony Server.
When an event causing a restart of the device, such as health check timeout, occurs during startup of the
Note:
configuration command, it takes about five minutes to start the rebooting after you exit from the configu-
ration command or enter the last command.
Starting Configuration Command
1.
Connect a PC to MG(PRI) using CONSOLE cable and run terminal software (e.g. HyperTerminal) on the
PC.
2.
Set the parameter of the terminal software as follows:
•
Port: COM1
•
Baud Rate: 9600 bps
•
Data: 8 bits
•
Parity: None
•
Stop Bit: 1
•
Flow Control: None
3.
Enter usrConsole after the OS prompt. Then the MG(PRI)'s prompt below appears.
- When Proprietary Protocol Mode is used
MG-PRI>
- When SIP mode is used
MG-PRI(SIP)>
_
_
VOL.2-1078
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]