NEC Univerge sv8500 Manual page 657

Hide thumbs Also See for Univerge sv8500:

Table of Contents

Trunk Line Appearance-D

Connecting an analog C.O. trunk and a virtual line one-to-one, this feature allows DtermIP user to directly

access C.O. line of MCMG by pressing corresponding Line key on DtermIP station, without dialing access

code. DtermIP station can also answer incoming calls from C.O. line by pressing the Line key.

MC MG1 MG3 MG5

MG0 MG2 MG4 MG6

Follow the service conditions below to use this feature by MCMG:

(a) System data assignment for Trunk Answer from Any Station (TAS) is required for this feature, but

the TAS service is not activated.

(b) Whether the Trunk Answer from Any Station (TAS) feature is available or not is determined by the

Service Feature Restriction Class (SFC: 34) setting to each station.

Don't Answer is activated, the LCD on the DtermIP does not display to inform the execution of call

(d) Analog C.O. line corresponding to PB signal is only applicable.

(e) DtermIP stations must assign a My Line on Line/Feature key beforehand.

(f) All the virtual lines of C.O. trunk, excepting My Line, can be assigned as Trunk Line Appearance-D

lines on one DtermIP station. (e.g. On 16-button type of DtermIP station, a maximum of 15 lines can

be accommodated as Trunk Line Appearance-D. The remaining one line is the My Line.)

(g) Up to 128 of C.O. lines can be accommodated as Trunk Line Appearance-D per system.

(h) Distinctive Ringing is not activated when incoming call terminates.

(i) Analog Telephone cannot answer the incoming call of Trunk Line Appearance-D.

Route Name: COT-3

Route Name: COT-2

Route Name: COT-1

MCMG Card [SCA-7COTA]

Table of Contents