NEC Univerge sv8500 Manual page 1165

SET Command
1. SET CALL_HOLD
Assign whether to use MG Based Call Retention or not.
MG-BRI(SIP)> SET CALL_HOLD P1
CALL HOLD setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
By setting "ENABLE" by this command, if a network failure occurred between the Telephony Server and
Note:
MG (BRI), the call will be retained. However, re-registration to the Telephony Server will not be executed.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
2. SET DEFAULT_GATEWAY
Assign the IP address of Default Gateway.
MG-BRI(SIP)> SET DEFAULT_GATEWAY P1
Default Gateway setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Specify the Default Gateway in the same subnet of MG(BRI).
Note:
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
3. SET DHCP_SV
Assign whether to use DHCP Server or not.
MG-BRI(SIP)> SET DHCP_SV
DHCP setting succeeded.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
Execute the "SAVE" command before finishing the maintenance command to reflect change.
Note:
P1
VOL.2-912
MG(BRI) [SCA-2BRIA/MG-2BRIA]
P1: ENABLE / DISABLE
ENABLE=CALL_HOLD is valid
DISABLE=CALL_HOLD is
invalid (default)
The result is shown.
P1: IP address of Default Gateway
(default: 0.0.0.0)
The result is shown.
P1: ENABLE / DISABLE
ENABLE=Using DHCP server
DISABLE=Not using DHCP server
The result is shown.